Need pictures of back of engine with wiring harness
02-15-2006, 07:07 PM
#1
TECH Apprentice
Thread Starter
iTrader: (12)
Join Date: May 2002
Location: Austin, TX
Posts: 386
Likes: 0
Received 0 Likes
on
0 Posts
Need pictures of back of engine with wiring harness Ok, so I have a wire in my harness that is wearing through somewhere on the back of the engine. I can't see very well under the cowl (T/A) - so it would be helpful if anyone has a pciture of what the wiring harness should look like.
My wires are way too tight (after heads/cam swap) and one of them has finally rubbed on a bracket long enough to ground out perdiodically and cut all spark. I need to re-route my wiring harness but I am not sure how it should actually look because it has been almost 2 years since the swap.
TIA
My wires are way too tight (after heads/cam swap) and one of them has finally rubbed on a bracket long enough to ground out perdiodically and cut all spark. I need to re-route my wiring harness but I am not sure how it should actually look because it has been almost 2 years since the swap.
TIA
