scotts94_z28

Ok i just purchased an LS6 intake manifold for my 98 SS and am going to install it along with a ported tb on my car. My question is what exactly do i need to install this on my 98 LS1 which will still have the stock exaust manifold on for a while?

you2slo

Does the new manifold have provisions for EGR?

conan

iTrader: (5)

You will need a block off plate for the pass side mainifold where the egr goes in.

scotts94_z28

no egr on the new manifold so will this http://www.texas-speed.com/shop/cate...MID=1&catid=12 and a block of plate for the pass side manifold be all I need? Also where can i get a blockoff for the exaust manifold?

Shallow Bay

iTrader: (3)

Yes

Here towards the bottom of the page.

daryl2cb@yahoo.com

iTrader: (2)

also new coolant lines and rear plugs.

Shallow Bay

iTrader: (3)

that's what his link was for.

scotts94_z28

awesome thanks everyone cant wait to get this and the ported tb on now its time to save for LT's, ory, stall, and nittos

indyboom

iTrader: (11)

stock manifolds are ok.. Im going to get another se and jet hot em, then get a better y pipe