Romac Balancer?
#1
Teching In
Thread Starter
Join Date: Oct 2005
Location: New York
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Romac Balancer?
Anybody using a "Romac" balancer? I bought one for a new engine project and it seems a bit small for the crank. I wondered if you guys might know a trick to fitting one of these. It's the lightweight one with the steel center & aluminum outer ring.
#3
Teching In
Thread Starter
Join Date: Oct 2005
Location: New York
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
LS1 - not quite! This balancer will be going on a 540 cid Pontiac engine. Then again, it might just be going back to "Romac" if it won't fit correctly. I've heard ideas from heating to honing. Any ideas guys?
#5
Teching In
Thread Starter
Join Date: Oct 2005
Location: New York
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Ahh, true. I forgot what site I was on! You LS1 guys have very limited mechanical knowledge outside of those little 350 motors you have.
Just kidding!
"Romac", what's a Romac???
Just kidding!
"Romac", what's a Romac???