will this fit?

Reply Subscribe

Thread Tools

Search this Thread

07-31-2006, 10:19 PM

Ego Killer

TECH Fanatic

Thread Starter

iTrader: (147)

Join Date: Feb 2003

Location: Tullahoma,Tn

Posts: 1,067

Likes: 0

Received 1 Like on 1 Post

will this fit?

I have 3"TD with an x pipe(just like TSP's) with bullet dynomaxs but its a little to load for me..so I traded the dynomaxs for some 2 chamber flowmasters..will they fit under the car good or did I screw up??

Reply Like

07-31-2006, 10:27 PM

orangeapeel

ЯєŧąяĐ Єl¡m¡иąŧøя ™

iTrader: (18)

Join Date: Nov 2004

Location: Justin, TX

Posts: 16,083

Likes: 0

Received 4 Likes on 4 Posts

Depends on where you plan on putting them. You might have a rattle problem too. Make sure, if you do run them, to put a hanger on the end off them because they are a considerable amount heavier than a bullet.

Reply Like

08-01-2006, 07:56 AM

TheBlurLS1

That's what she said...

iTrader: (8)

Join Date: Mar 2004

Location: Nederland Texas

Posts: 7,954

Likes: 0

Received 2 Likes on 2 Posts

I've got a 5" diameter bullet running between my driveshaft and tranny tunnel. You can make anything fit with a big enough hammer.

Reply Like

08-01-2006, 09:03 AM

LS69TA

TECH Veteran

iTrader: (30)

Join Date: Jan 2003

Location: Texarkana, Tx

Posts: 4,391

Likes: 0

Received 0 Likes on 0 Posts

You may want to move them so that they fit under the rear pass. seats. I had mine in that general location on my Camaro and didn't have to beat on anything to make them fit.

Reply Like

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last