Intake bolt torque specs
11-01-2006, 08:52 PM
#1
Staging Lane
Thread Starter
Join Date: May 2006
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
Intake bolt torque specs Does anyone know the torque specs off the top of there head for the lingenfelter intake bolts? Im not sure if it matters but the stock intake torque numbers might work also. any would be appreciated
thanks guys
Corey
thanks guys
Corey
11-01-2006, 09:03 PM
#2
I believe the stock specs are 11 ft lbs first pass, 17-18 ft lbs second pass.
* Edit - Mitchell says 44 inch lbs first pass, 89 inch lbs second pass.
I just put my headers on a while ago and got mixed up.
* Edit - Mitchell says 44 inch lbs first pass, 89 inch lbs second pass.
I just put my headers on a while ago and got mixed up.
Last edited by 2002 SS #476; 11-01-2006 at 09:11 PM.
11-01-2006, 09:06 PM
#3
TECH Addict
iTrader: (6)
Join Date: Jun 2005
Location: Ft. Bragg, NC
Posts: 2,210
Likes: 0
Received 0 Likes
on
0 Posts
i assume those numbers related to these...
Intake Manifold Bolts (First Pass in Sequence) 44 lb in
Intake Manifold Bolts (Final Pass in Sequence) 89 lb in
outta ls1howto.com
Intake Manifold Bolts (First Pass in Sequence) 44 lb in
Intake Manifold Bolts (Final Pass in Sequence) 89 lb in
outta ls1howto.com
11-02-2006, 05:17 PM
#6
Staging Lane
Thread Starter
Join Date: May 2006
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
Oh i see inch lbs is a completely different torque measurement. It says on ls1howto that hand tightening then finally torqueing to 7 ft lbs. should work out with a RUBBER gasket. Do you think that would be fine with a paper one?
