Idler Pulley Questions
#1
Launching!
Thread Starter
iTrader: (9)
Join Date: Nov 2004
Location: Wilmington, NC
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
Idler Pulley Questions
My belt got destroyed because pulley was dead, bearings showing etc . I bought a new pulley.
I have 3 pieces as shown in the picture:
pulley, front piece and back piece..and the bolt of course.
I tighten the bolt down and the pulley will not turn by hand. I tried the back dustshield both ways, not sure what the problem is here. When the pulley is off it works great.
I have 3 pieces as shown in the picture:
pulley, front piece and back piece..and the bolt of course.
I tighten the bolt down and the pulley will not turn by hand. I tried the back dustshield both ways, not sure what the problem is here. When the pulley is off it works great.
#2
TECH Apprentice
iTrader: (16)
Join Date: Jan 2006
Location: Tulsa OK
Posts: 372
Likes: 0
Received 0 Likes
on
0 Posts
Is this on an LS1?
If so I don't see how it could be stopping it unless you got a big washer on it or something. I've changed my pulley twice over the years and not had any sort of problem. The bolt head tightens against the side of bearing, no realy way it could stop it. Maybe they sold you the wrong pulley.
If so I don't see how it could be stopping it unless you got a big washer on it or something. I've changed my pulley twice over the years and not had any sort of problem. The bolt head tightens against the side of bearing, no realy way it could stop it. Maybe they sold you the wrong pulley.