28'' Bullet
#1
TECH Enthusiast
Thread Starter
iTrader: (8)
Join Date: Jan 2007
Location: Orange County, CA
Posts: 563
Likes: 0
Received 0 Likes
on
0 Posts
28'' Bullet
I am installing a 28'' bullet tomorrow and was wondering what i should have the shop fab up to hold it.
It will go from the Y-Pipe into the bullet to dump at the axle.
Suggestions on were to fab or to use to hold it up?
It will go from the Y-Pipe into the bullet to dump at the axle.
Suggestions on were to fab or to use to hold it up?
#6
TECH Enthusiast
Thread Starter
iTrader: (8)
Join Date: Jan 2007
Location: Orange County, CA
Posts: 563
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by TheSecretFormula
Just have them put a hanger right under the rear passenger seat.
Any suggestions about monting right in the center by the driveshaft( )