kuzyawd/rwd

iTrader: (7)

hello everyone i bought some kooks race headers and know im installing them but thier just not fitting dont know what im doing wrong pass side when in fine but driver sides kicking my *** i keep getting stuck between oil filter mount and the k member please give me some input i would greatly apprieciate it thanks

Black02Bird

iTrader: (5)

did you trim your casting tab on the block? mine wouldnt go in till i cut that ****** off with the sawzall...

Da Swami

iTrader: (6)

It sounds like he's stuck before the tab if I'm reading correctly.

Cutting the tab is what did it for me, but I was on poly mounts. You might need to jack the motor just a hair, maybe?

Oh, and FULLY VERTICAL, remember.

98Camarod

iTrader: (43)

I have my floorboard a few taps with a hammer and it slid right in

illing1106

iTrader: (3)

just put some lt's in yesterday, just put some *** into it they will go, might dent up the oil filter a little but thats about it

kuzyawd/rwd

iTrader: (7)

well thanks guys for the input going to try to put them in when it isnt a 100 f***ing degrees out thanks again

TUFAS4U

iTrader: (5)

did you follow the instructions carefully, make sure you drink at least 6 beers during the install. works wonders

blkbird

iTrader: (28)

I second that motion!!!!

ez98ls1

iTrader: (2)

beer and modding goes hand in hand.

g-ryde1

iTrader: (3)

+2 on that

when we installed them on a 02 SS we just diconnected the driverside motor mount and jacked one side of the engine up and the sucker slid right in. a lil work but it got the job done.

01CamaroZ28

iTrader: (9)

casting tab removed and it worked for me....

fastjarred98

iTrader: (5)

is there a sticky on installing longtubes? just curious

g-ryde1

iTrader: (3)

if not there needs to be