Help! TB keeps getting stuck open
#1
14 Second Truck Club
Thread Starter
iTrader: (6)
Join Date: Sep 2002
Location: Bossier City, LA
Posts: 2,343
Likes: 0
Received 0 Likes
on
0 Posts
Help! TB keeps getting stuck open
I've got a bluemaxx 90mm tb that I ordered from vengence racing along with my ported 90mm FAST intake. Every time I give it gas after I installed it, it gets stuck open and will not go down unless I manually close it. When the motor isn't running, it's fine. I did the TPS relearn and fixed a small leak from the plastic fitting that's on there. I even took my intake off to check the gaskets and have checked everything possible. It's driving me crazy! Please help! Thanks!
#2
wow. this is the third Bluemaxx thorttle 90mm that i know of that has this issue. My buddy has this same one i got bad news its in the throttle body and the way its assembled i belive. Call them up and explain to them that you want a replacement or return it and get NW one.
#3
is it the throttle blade? if so unscrew it, use a marker and run it around the outside, reinstall it, open and close it a few times, see where it rubs, then pull it back off, sand down the edges with some sandpaper, and repeat until no more marks rub off the outside of the throttle blade.
#4
11 Second Club
iTrader: (8)
wow. this is the third Bluemaxx thorttle 90mm that i know of that has this issue. My buddy has this same one i got bad news its in the throttle body and the way its assembled i belive. Call them up and explain to them that you want a replacement or return it and get NW one.
#5
14 Second Truck Club
Thread Starter
iTrader: (6)
Join Date: Sep 2002
Location: Bossier City, LA
Posts: 2,343
Likes: 0
Received 0 Likes
on
0 Posts
I've messed with the idle screw all day, hasn't done ****. Btw, forgot to add that with adjusting the idle screw where it should be, the damn truck won't even start & sticks like hell with it off. When I barely adjust it to where it will start, the lowest it's idled has been 875-900 rpms.
Last edited by Hemi Killer; 10-27-2007 at 03:53 AM.
#7
Trending Topics
#11
14 Second Truck Club
Thread Starter
iTrader: (6)
Join Date: Sep 2002
Location: Bossier City, LA
Posts: 2,343
Likes: 0
Received 0 Likes
on
0 Posts
I was gonna get the nick williams, but byunspeed had the UMI 90mm for $419 shipped! I went ahead and ordered it. Never seen anything bad about these so far.