HAZ-Matt

iTrader: (8)

Sorry for a simple question, but I did a search and didn't get a clear answer. What size coupler will I need to connect an 85mm GM MAF to an SLP airlid designed for the stock MAF? I saw one reference that both the MAF and the lid are both 98mm external diameter. Is this correct? I think that works out to a somewhat unusual coupler size... ie ~3.6inches. If this is the case, did you guys who have added this expanded a 3.5in coupler?

Thanks.

ssgunny

iTrader: (6)

I have the SLP lid and Delphi 85mm MAF. I went with a 3.75" ID and it fit snug on both. I sent you a PM on a place to look. Good luck.

YellowToy/A

iTrader: (1)

You will need a tune. Else your air/fuel ratio will be way off.

ssgunny

iTrader: (6)

My SES light came on after about 10 miles or so after having the new MAF installed. I did the reset by unplugging the IAC and TPS from the TB and then reconnected. 10 miles later the light came back on. Luckily I had a friend that did a part throttle tune for cheap.

HAZ-Matt

iTrader: (8)

I have HPTuners and am going to use the correct MAF table, so no worries there.

ssgunny

iTrader: (6)

Here are a couple different views of my setup. Only thing I can think of is the inside diameter (ID) of your coupler is not 3.75". I didn't not have to heat anything up to get to it to fit.

Check the PM I sent you for the specific one that I ordered.

ls1owner4life

iTrader: (17)

Bump, looking for what size silicone couplers to buy with stock MAF and TB. Thanks.

LS1BLKSS

iTrader: (36)

where can i buy these couplers or elbows?? i remember there was a site that had all kinds of sizes... i can't find it anymore! can someone pm the site?

94'BLKBRD

iTrader: (76)

Ebay has couplers

http://search.ebay.com/search/search...fsoo%3D2&fgtp=

SarGntoperez

where did you get the coupler and whats the length of it? Sorry i know its been long time of this posts

big hammer

I was able to stretch my coupler over

SarGntoperez

Where can i find one and whats the dimensions? Also what setup did you had?

redbird555

iTrader: (14)

If you all go to pep boys they sell a black silicone coupler that fits the maf and the lid perfectly