FAST 92mm setup
#1
TECH Enthusiast
Thread Starter
iTrader: (9)
Join Date: Dec 2003
Location: Edmond,OK
Posts: 563
Likes: 0
Received 0 Likes
on
0 Posts
FAST 92mm setup
I have seen a few threads about the new 92mm intake maifold but not much talk about the Big mouth 92mm TB. I know the FAST 90mm wasnt great thats why Nick willaims and others were a better choice. but has FAST made there 92mm TB better.
Anyone out there have this setup. I am wanting to put it on my 396ci stroker. I think it will help over the LS6 manifold
Thanks
Anyone out there have this setup. I am wanting to put it on my 396ci stroker. I think it will help over the LS6 manifold
Thanks
#4
LS1Tech Premium Sponsor
iTrader: (4)
We have 92mm PTM throttle bodies in stock & ready to ship! We're also receiving the first batch of PTM 95mm throttle bodies later in the week! Give me a call if you need a intake or a throttle body!
__________________
Jason
Co-Owner, Texas Speed & Performance, Ltd.
2005 Twin Turbo C6
404cid Stroker, 67mm Twins
994rwhp/902lb ft @ 22 psi (mustang dyno) www.Texas-Speed.com
Jason
Co-Owner, Texas Speed & Performance, Ltd.
2005 Twin Turbo C6
404cid Stroker, 67mm Twins
994rwhp/902lb ft @ 22 psi (mustang dyno) www.Texas-Speed.com
#5
Moderator
iTrader: (4)
Join Date: Nov 2003
Location: Plainfield, CT
Posts: 10,520
Likes: 0
Received 0 Likes
on
0 Posts
Not enough of them out yet to tell if they are any good or not. It will take a while for threads to start popping up.
Tony Mamo posted in a thread that the FAST 92 can not be ported to 95mm, because the gasket is not even 95mm.
Tony Mamo posted in a thread that the FAST 92 can not be ported to 95mm, because the gasket is not even 95mm.
#7
TECH Enthusiast
Thread Starter
iTrader: (9)
Join Date: Dec 2003
Location: Edmond,OK
Posts: 563
Likes: 0
Received 0 Likes
on
0 Posts
I was just going to wait on getting this, but my stock TB is acting weird, it reads 1% open at idle and will not go into idle mode,so as funny as it sounds it idles like crap. and I have replaced the tottle postion sensor and it still is acting like that so I think its the TB. so I figured I would replace it with the manifold and TB I want but I dont know which one to get.
I want it to look great and perform great.
I want it to look great and perform great.