Removing MAC midlength headers
07-20-2008, 08:39 PM
#1
Staging Lane
Thread Starter
iTrader: (3)
Join Date: Mar 2007
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
Removing MAC midlength headers I'm trying to drop these MAC midlength headers off of my car and I'm completely lost. I've tried jacking the engine a bit, removing the coil pack bracket, and every position possible without any luck on either side. Any suggestions, I'm going crazy here. Thanks
.
07-20-2008, 09:52 PM
#4
Launching!
iTrader: (35)
Join Date: Oct 2006
Location: Chandler, AZ
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
Last set I removed literally fell out. Some of the typical clearancing items for header installs are removal of the oil filter, removal of the pass side heat shields and disconnecting the steering shaft from the steering box.
07-20-2008, 11:08 PM
#5
On The Tree
iTrader: (4)
Join Date: Jan 2006
Location: middle of nowhere ca.
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
i had to loosen up my motor mounts one side at a time and and then jack up the motor from the pan in order to get mine out. i guess not everyone has the same clearincing on there cars. i would say try that if you hadnt already.
07-21-2008, 01:09 AM
#7
TECH Regular
iTrader: (8)
Join Date: Apr 2008
Location: California
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
I wouldnt recommend jacking the car from the oil pan...
And disconnecting the Steering shaft always did it for me , good to see you got it out though... Didnt like the Mac's ??
And disconnecting the Steering shaft always did it for me , good to see you got it out though... Didnt like the Mac's ??
