Is .010 too tight for rod bearing side clearance?
#1
TECH Apprentice
Thread Starter
Join Date: May 2006
Location: Nebraska
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
Is .010 too tight for rod bearing side clearance?
Just measured rod side clearance on new 418 build...the side rod clearance is approx .008 -.010. ....has anyone run clearance this tight on the rods without any problem? I have no problem pulling the rods back out to file off some more clearance....just want to see what everyone else has done? Thx-Stroker2112