Main and rod bearing question!! please help!
#1
Teching In
Thread Starter
iTrader: (4)
Join Date: Jul 2011
Location: Kansas City Missouri
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Main and rod bearing question!! please help!
So when i had my lm7 block all cleaned up fro building it, he told me i should use GM main and rod bearings? he said that if i dont the aftermarket ones can be off just by thousands of an inch but can add up. I have the whole rebuild kit already bought and ready to go but im kinda stuck on this, i dont know if i would be fine to run sealed power bearings or go with GM bearings?
Please let me know what you guys think!
Please let me know what you guys think!
#2
TECH Fanatic
iTrader: (35)
You need to check your clearances regardless of what bearings you use,, I have never heard of that theory of aftermarket being off as compared to oem,, Some bearings are better than others, I have the king alleculars in mine, But You cant go wrong with Clevite 77 they have been around forever. I think that the sealed powers are made by federal mogul, they have been around for a while also. Check your clearances if they are in spec, you should be good to go.
#3
Teching In
Thread Starter
iTrader: (4)
Join Date: Jul 2011
Location: Kansas City Missouri
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
I've also never heard of it either, when I had it all done at the machine shop he said all the specs were good for standard bearings but I will check them also to make sure they are the right specs