power estimate on lq4
01-19-2010, 06:20 PM
#1
Launching!
Thread Starter
iTrader: (1)
Join Date: May 2009
Location: easton, md
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
power estimate on lq4 think you guys could tell me how much power i should be looking at? setup is-
lq4 bottom end with arp rod bolts
238/242 .580/.590 112 cam
cnc ported 806 heads
.042 felpro's
edelbrock victor jr intake
holley 750dp
modified factory manifolds with 3'' outlets (i know but its the best i can do without gettin a k member for now-mustang)
msd 6010
this will be through a turbo 350 with a 3500-3800 stall. what you guys think?
lq4 bottom end with arp rod bolts
238/242 .580/.590 112 cam
cnc ported 806 heads
.042 felpro's
edelbrock victor jr intake
holley 750dp
modified factory manifolds with 3'' outlets (i know but its the best i can do without gettin a k member for now-mustang)
msd 6010
this will be through a turbo 350 with a 3500-3800 stall. what you guys think?
01-20-2010, 01:43 AM
#3
im not sure what your setup will make but i read in car craft magazine about a 99 lq4 motor they put a carb on and it made 450+ i dont member the exact numbers but i do member it was 450+. they used a 99 lq4 stock bottom end and stock iron heads and stock cam. a edelbrock mani msd box and a 750 holley. but also ran long tubes. hope this gives you an idea.
02-08-2010, 03:24 PM
#4
im not sure what your setup will make but i read in car craft magazine about a 99 lq4 motor they put a carb on and it made 450+ i dont member the exact numbers but i do member it was 450+. they used a 99 lq4 stock bottom end and stock iron heads and stock cam. a edelbrock mani msd box and a 750 holley. but also ran long tubes. hope this gives you an idea.
