How to install Chamfered Rod Bearings?
#1
Banned
Thread Starter
Join Date: Sep 2002
Location: So Cal, CA
Posts: 1,298
Likes: 0
Received 0 Likes
on
0 Posts
How to install Chamfered Rod Bearings?
Ack, i always get stuck with people asking me questions i dont know.
Our engine builder isnt around for this week so i cant ask him!
Ive got some 8-7100CH Federal Mogul Rod Bearings
They appear to be chamfered from looking at them on one side.
Whats the correct way to install these in a rod?? (stock rods, stock crank)
Our engine builder isnt around for this week so i cant ask him!
Ive got some 8-7100CH Federal Mogul Rod Bearings
They appear to be chamfered from looking at them on one side.
Whats the correct way to install these in a rod?? (stock rods, stock crank)
#6
Senior Member
iTrader: (24)
Join Date: Nov 2001
Location: Tampa, FL
Posts: 6,034
Likes: 0
Received 0 Likes
on
0 Posts
If its a STOCK crank, it really doesnt matter as the stock crank has NO fillets, but like the other said, the *right* way is for the chamfers to point to the crank throw and the flat against the other rod. Itll look funny since LS1 rods have the chamfers all pointing the same way and not the traditional SBC way
Trust me, I have LOTS of experience in this
Trust me, I have LOTS of experience in this