Balancer Position
01-01-2011, 10:40 PM
#1
On The Tree
Thread Starter
iTrader: (2)
Join Date: May 2008
Location: Arizona
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
Balancer Position During my cam swap I pulled the harmonic balancer off and did not mark the rotational position (crank vs. balancer). This is on an 03' LQ4 motor. The balancer is not keyed. Reading the directions for my cam it states that this needs to be marked and replaced in the exact orientation, yet alldata says nothing about balancer position. Is this something I should worry about? Thanks
