1sicss

iTrader: (3)

I will probably have this running by next Wednesday assuming that I get the oil pump here by then. I'm placing this on my 98' Z28 with all supporting mods any tips or advice is welcomed before I begin to tear this bad boy apart. Can't wait to feel and here what this bad boy will feel like. How does the break in work for the valve springs since they will be new is it one or two heat cycles? Can't wait wish me luck.

A.R. Shale Targa

iTrader: (2)

That cam should run real well................good luck w/your project

*02WS6TURK*

iTrader: (13)

My buddy just put that cam in his camaro with some bare bone LS6 heads. It's putting down roughly 420rwh through a stalled A4. It's a beast.

1sicss

iTrader: (3)

Damn, I can't wait to drive it with this cam.

ds98formula

iTrader: (3)

Thats the cam I want to go with. When will you have it tuned? What are your other mods? Very intersted in the resultes

usmonaro

Did you get the optional .650 lift beehives? That's what I ended up going with on my torquer v.2 package. Good luck with the build.

Sales4@Texas-Speed

iTrader: (4)

All you need to do is heat cycle the springs once or twice and you should be good to go for any "break-in" procedures. Make sure to get it tuned and it should run pretty well! Let us know how you like it.

shorty(98TA)

I got my torquer3 cam pak in today as well. i also have a ls6 intake waiting to go on the only hold up will be finding a good mechine shop in my area to put the new spring seats in the heads for me

ds98formula

iTrader: (3)

Interested in you results too. Also what other mod do you have

shorty(98TA)

^its a work in progress right now the car is bone stock. ive been just piling up parst for it right now ive got a volant CAI, p/p TB, ls6 intake, torquer3 cam all waiting to go on still have to order up some exhaust then ill do it all at the same time

ds98formula

iTrader: (3)

Have you dynoed it for a base line?

WS6tx

iTrader: (25)

I jus picked up the same cam, jus waitin to install it. Very interested in your results.

1sicss

iTrader: (3)

Well I have K&N FIPK, UDpulley, ported tb, LS6 intake, free mods, LT headers, ory, LM1, and after speaking to the TSP staff I opted to send in my pcm to have a mail order tune since they have tuned hundreds of vehicles with this cam and the maker of it so I'm pretty sure it will run good.

ds98formula

iTrader: (3)

^^ are you going to do a dyno pull just to see what it makes and check air fuel ratio?

shorty(98TA)

i havent done a base line dyno, every part i have is sittn in my closet and all going on at once. the instilation starts monday then ill take it in for a tune