FAST 92 not lining up with 243 milled heads? opinions needed
#1
FAST 92 not lining up with 243 milled heads? opinions needed
Is there a max for milling the heads so the FAST still lines up ok with the heads?
Should I be concern with that and just mill the heads .015 to get around 10.8-11 or dont care and mill to get 11.5?
Any input would be greatly appreciated..
heads are ported 243s going on a LS1 with valverelief/pistons.
Should I be concern with that and just mill the heads .015 to get around 10.8-11 or dont care and mill to get 11.5?
Any input would be greatly appreciated..
heads are ported 243s going on a LS1 with valverelief/pistons.
Last edited by Johnnystock; 02-29-2012 at 05:46 PM.