VandykeT/A

I've looked around online for the torque specs for the cylinder heads and all I've found is the 22ft lbs and then degrees on LS1 how to but it talks about M11 and M8 bolts. Then I found where it said like 50lb ft with arps. Can someone tell me what to torque what head bolts to. I'm sure this info is out there somewhere but I just can't find it.

mark21742

What bolts are you using, stock, or ARP? stock goes in degrees and are torque to yeild, ARP bolts have ftlb specs

badazz81z28

iTrader: (6)

GM bolts are torque to yield which is degrees of turn. ARP is a torque spec as they are not TTY.

What are you using?

VandykeT/A

I'm going to be using new gm head bolts.

badazz81z28

iTrader: (6)

LS1 How do, does have instructions...Not sure if I would trust it or not.

hcb1700

iTrader: (9)

I've used the ls1 method multiple times and it's worked great. As a matter of fact, I just installed new heads on my 2000 SS and used that method. By the way, the sharpie tip mentioned on the site really helps.

427LS7HCI

Stock bolts are degree'd and ARPs are torque spec'd