How to protect wire loom from passenger side TSP 1 7/8 LT header in '02 WS6?
06-23-2013, 05:20 PM
#1
Launching!
Thread Starter
iTrader: (1)
Join Date: Apr 2013
Location: Los Angeles, CA
Posts: 254
Likes: 0
Received 0 Likes
on
0 Posts
How to protect wire loom from passenger side TSP 1 7/8 LT header in '02 WS6? I noticed that the reflective heat wrapped wire loom that rests on the inner fender well on the passenger side is basically touching the primary on my TSP 1 7/8 passenger side header (will put up a pic later). Up until the fuel pump died the car was running perfectly so I hope nothing has happened to the wires inside so far but I have driven around 1000 miles with the headers so far in the last month. From what I remember reading a few days back the O2 sensor and starter wires are in there? What have you guys done to protect these wires?
