Cant remove main caps after stud install
#1
On The Tree
Thread Starter
Cant remove main caps after stud install
Had my machine shop do an align hone and now I can't remove the main caps to get the bearings/crankshaft in. Wasn't nearly this hard when tearing the engine down. Had to use a pry bar, but it still was feasible. Any suggestions on what to do?
#3
TECH Enthusiast
iTrader: (17)
Join Date: Sep 2007
Location: Southern NJ
Posts: 634
Likes: 0
Received 0 Likes
on
0 Posts
there is a special tool designed for pulling the caps.
You might check with local parts stores to see if any rent them out.
I purchased one on here a while back.
https://ls1tech.com/forums/attachmen...-nu-q-60_1.jpg
You might check with local parts stores to see if any rent them out.
I purchased one on here a while back.
https://ls1tech.com/forums/attachmen...-nu-q-60_1.jpg
Trending Topics
#8
TECH Apprentice
iTrader: (16)
there is a special tool designed for pulling the caps.
You might check with local parts stores to see if any rent them out.
I purchased one on here a while back.
https://ls1tech.com/forums/attachmen...-nu-q-60_1.jpg
You might check with local parts stores to see if any rent them out.
I purchased one on here a while back.
https://ls1tech.com/forums/attachmen...-nu-q-60_1.jpg