milling 6.0L heads and a cam choice???
06-24-2004, 06:58 PM
#1
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Dec 2001
Location: DFW, TX.
Posts: 93
Likes: 0
Received 0 Likes
on
0 Posts
milling 6.0L heads and a cam choice??? if I mill down my 6.0L #317 heads .030" , and slap then on an LQ4 shortblock....
what will the CR be ??? about 10:1 ???
gameplan.....buying 6.0L LQ4 shortblock, milling 6.0L heads .030", using stock 5.3L intake, rails, coil packs and accessories, Supermaxx headers and Y pipe
WHat would a good cam be for this in my Suburban.......bere in mind that it is a towing vehicle, I drag my big azz boat with it......so I need all my grunt down low, but wanna bust some azz for fun
whatchya think????
thanks
RAT
what will the CR be ??? about 10:1 ???
gameplan.....buying 6.0L LQ4 shortblock, milling 6.0L heads .030", using stock 5.3L intake, rails, coil packs and accessories, Supermaxx headers and Y pipe
WHat would a good cam be for this in my Suburban.......bere in mind that it is a towing vehicle, I drag my big azz boat with it......so I need all my grunt down low, but wanna bust some azz for fun
whatchya think????
thanks
RAT
