CAM Install - Can't remove #2 Lifter
08-21-2004, 07:53 PM
#1
11 Second Club
Thread Starter
iTrader: (2)
Join Date: Nov 2001
Location: NY
Posts: 583
Likes: 0
Received 0 Likes
on
0 Posts
CAM Install - Can't remove #2 Lifter The other ones just popped out with a magnet tool but this one seems determined to stay in there.
How do I get this out? And is that a sign of anything or are they just hard to get out sometimes?
How do I get this out? And is that a sign of anything or are they just hard to get out sometimes?
08-21-2004, 08:08 PM
#3
11 Second Club
Thread Starter
iTrader: (2)
Join Date: Nov 2001
Location: NY
Posts: 583
Likes: 0
Received 0 Likes
on
0 Posts
JRP... I'm the retarded pen magnet guy who had to pull his heads to get the magnet out 
The heads are off, the lifter retainers are off and I finally just a second ago got the lifter out. I just got my fingers around it and wiggled and pulled and it eventually came out... not nearly as easy as the other 7 however.
J.C. the last thing I need is something else to go wrong during this install
I did notice a small pit in my #2 piston the size that looks like dip about the width of a piece of pencil lead and punched it into the piston. It isn't really deep but I have no idea if that is good / bad or ugly.
The heads are off, the lifter retainers are off and I finally just a second ago got the lifter out. I just got my fingers around it and wiggled and pulled and it eventually came out... not nearly as easy as the other 7 however.
J.C. the last thing I need is something else to go wrong during this install
I did notice a small pit in my #2 piston the size that looks like dip about the width of a piece of pencil lead and punched it into the piston. It isn't really deep but I have no idea if that is good / bad or ugly.