I wanna start with a 6.0 Short Block, What do I need???
#1
TECH Apprentice
Thread Starter
Join Date: Nov 2003
Location: Detroit
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts
I wanna start with a 6.0 Short Block, What do I need???
Alright, I wanna start with a 6.0 Short Block... I was wonderin what would be everything I need to build it up...
I would be buildin this for a S/C so I want low compression right... I also wanna put a LS6 Intake (Best flowing right??) Because I plan to do either the whipple or kenne bell and want to do an intercooler setup like Ryan23's...
Also if you guys could post up some average prices for all of these things that would be great... I wanna be able to figure out what kinda damage this thing's gonna cause me... Thanx.
I would be buildin this for a S/C so I want low compression right... I also wanna put a LS6 Intake (Best flowing right??) Because I plan to do either the whipple or kenne bell and want to do an intercooler setup like Ryan23's...
Also if you guys could post up some average prices for all of these things that would be great... I wanna be able to figure out what kinda damage this thing's gonna cause me... Thanx.
#2
TECH Fanatic
iTrader: (1)
Join Date: May 2003
Location: St Clairsville, Oh
Posts: 1,387
Likes: 0
Received 0 Likes
on
0 Posts
Pistons 600 (-15cc)
Rings 180
Rods 400 You can use SBC
crank 200 for a stock one $1000 for a foged one
Cam 400 new
spings and retainers 300
Main studs 180
Head studs 220
heads (317 6.0) 200-300 this will help with the 8.75 CR
Headers 500
Exhauset 500
Meching work 600-850 This will include bearings,vatting,boring,powerhoning,pressing new cam bearings,and balencing the motor internaly.
New tranny 1500-2500 Depending on what u break in your tranny
LS6 intake 300-400
Injector 300-400
Fuel rails 150-200
fuel pump 150
MagnaCharger 5,150 for the sliver one 5,850 for the polished one.
And lets just say 500 for any other **** that i fogot.
Total $12,330-$15,430 not assembled or installed.
Hey look a new car.
Rings 180
Rods 400 You can use SBC
crank 200 for a stock one $1000 for a foged one
Cam 400 new
spings and retainers 300
Main studs 180
Head studs 220
heads (317 6.0) 200-300 this will help with the 8.75 CR
Headers 500
Exhauset 500
Meching work 600-850 This will include bearings,vatting,boring,powerhoning,pressing new cam bearings,and balencing the motor internaly.
New tranny 1500-2500 Depending on what u break in your tranny
LS6 intake 300-400
Injector 300-400
Fuel rails 150-200
fuel pump 150
MagnaCharger 5,150 for the sliver one 5,850 for the polished one.
And lets just say 500 for any other **** that i fogot.
Total $12,330-$15,430 not assembled or installed.
Hey look a new car.
Last edited by goober35; 12-20-2004 at 11:25 AM.