LS1TECH - Camaro and Firebird Forum Discussion

Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

Question about intake

Thread Tools
 
Search this Thread
 
Old 01-27-2005, 05:57 PM
  #1  
12 Second Club
Thread Starter
iTrader: (1)
 
smask04C5's Avatar
 
Join Date: Dec 2004
Location: Winter Haven, Fl.
Posts: 607
Likes: 0
Received 1 Like on 1 Post

Default Question about intake
is there anything you use to seal intake to heads on ls1 or does it go together clean and dry?
smask04C5 is offline  
Reply Like
Old 01-27-2005, 06:03 PM
  #2  
TECH Senior Member
iTrader: (10)
 
cyphur's Avatar
 
Join Date: Mar 2003
Location: North Texas
Posts: 8,009
Likes: 0
Received 0 Likes on 0 Posts
Default
intake port rubber gaskets...may come with your intake unless its a FAST.
cyphur is offline  
Reply Like
Old 01-27-2005, 06:50 PM
  #3  
12 Second Club
Thread Starter
iTrader: (1)
 
smask04C5's Avatar
 
Join Date: Dec 2004
Location: Winter Haven, Fl.
Posts: 607
Likes: 0
Received 1 Like on 1 Post

Default
h/c swap on a 04 C5, only has 2400 miles, just wondered if you should change the intake port o-rings, look fine
smask04C5 is offline  
Reply Like
Old 01-27-2005, 07:39 PM
  #4  
TECH Senior Member
iTrader: (10)
 
cyphur's Avatar
 
Join Date: Mar 2003
Location: North Texas
Posts: 8,009
Likes: 0
Received 0 Likes on 0 Posts
Default
don't worry about them if they look to be in good condition.
cyphur is offline  
Reply Like
Old 01-27-2005, 07:43 PM
  #5  
12 Second Club
Thread Starter
iTrader: (1)
 
smask04C5's Avatar
 
Join Date: Dec 2004
Location: Winter Haven, Fl.
Posts: 607
Likes: 0
Received 1 Like on 1 Post

Default
thanks
smask04C5 is offline  
Reply Like
Back to Subforum
Generation III Internal Engine
View Next Unread
Anyone kno "elgin"




Advanced Search

All times are GMT -5. The time now is 07:31 PM.