before I put the heads on...
#1
TECH Enthusiast
Thread Starter
Join Date: Jul 2003
Location: fortress of solitude
Posts: 608
Likes: 0
Received 0 Likes
on
0 Posts
before I put the heads on...
I noticed there is a slight knotch in between the cylinder chambers. you can feel it if you run your finger over it. I'm not sure if its going to hurt anything. These heads are used and from the inprint of the old gaskets it looks like this piece is right in between the chambers and is not part of either of them. I will try to get some pics up today. Any suggestions? Comments?
#2
Launching!
iTrader: (1)
Join Date: Mar 2005
Location: North Pole
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by KALEL
I noticed there is a slight knotch in between the cylinder chambers. you can feel it if you run your finger over it. I'm not sure if its going to hurt anything. These heads are used and from the inprint of the old gaskets it looks like this piece is right in between the chambers and is not part of either of them. I will try to get some pics up today. Any suggestions? Comments?