Phil99vette

iTrader: (11)

I need a piece of M16 x 2.00 to seat the crank pulley. Can I get this locally?
Phil

HumpinSS

iTrader: (1)

Go to the autozone and rent a pulley installer. Then go to the hardware store and get some all thread 3/8" rod cut it down some screw the end of the installer into the crank and pull the pulley on. That is usually the way I do mine

ROCNDAV

iTrader: (100)

I found mine at a local hardware store. Just call around and ask for metric threaded rod.

David

Frans96SS

iTrader: (15)

yeah i found mine at a local place i know that sells a bunch of nuts and bolts..... i go there for all my stuff......2 nuts and a peice of all thread was like 6 bucks

SidewaysTA

iTrader: (11)

Yep, about the same here too. Cost me less than $8. Look in your yellow pages for businesses that deal exclusively with bolts and screws and other fasteners. That is usually where you will get the best deal. For example, in my area we have two such businesses, named Ace Bolt and Screw and Mac Steel and Bolt Co. Look for businesses like that.

Mike

vettenuts

iTrader: (4)

I ordered it from McMaster Car. Got the nuts yesterday, still waiting on the threaded rod.