PTV clearance help
#1
High on diesel fumes
Thread Starter
iTrader: (70)
Join Date: Mar 2005
Location: Phoenix, AZ
Posts: 12,333
Likes: 0
Received 0 Likes
on
0 Posts
PTV clearance help
Trying to figure out if I'll be ok.
Cam:
Intake lift @ TDC - .129"
Exhaust lift @ TDC - .096"
235/239-600/580-113+4 cam
Pistons are diamond p/n 11576, valve reliefs are .165" intake and .107" exhaust.
I am using a .04" thickness head gasket. Heads are TSP stage 2.5 LS6 heads, and were "cleaned up", not milled, probably .003-.004. Block was decked about .010". Piston is about .010" out of the hole at TDC. Am I going to have problems? Intake looks ok, but I think I might be cutting it too close on exhaust.....not sure though.
2.04 intake valve and 1.575 exhaust.
Cam:
Intake lift @ TDC - .129"
Exhaust lift @ TDC - .096"
235/239-600/580-113+4 cam
Pistons are diamond p/n 11576, valve reliefs are .165" intake and .107" exhaust.
I am using a .04" thickness head gasket. Heads are TSP stage 2.5 LS6 heads, and were "cleaned up", not milled, probably .003-.004. Block was decked about .010". Piston is about .010" out of the hole at TDC. Am I going to have problems? Intake looks ok, but I think I might be cutting it too close on exhaust.....not sure though.
2.04 intake valve and 1.575 exhaust.
#3
TECH Fanatic
iTrader: (8)
i'm gonna guess u'll be okay...but you should measure. Check out my post, 6 down. https://ls1tech.com/forums/generation-iii-internal-engine/515456-ptv-measurement.html