anyone running 3/8" pushrods?
#1
10 Second Club
Thread Starter
iTrader: (128)
Join Date: Jun 2005
Location: Meridian, MS
Posts: 778
Likes: 0
Received 0 Likes
on
0 Posts
anyone running 3/8" pushrods?
i'm just wandering if anyone else is/has/going to step up to a 3/8" pushrod in their LSx?
i've had some valvetrain issues in the past & now that the motor is getting a freshen up i am working on making the valvetrain almost bullet proof. the motor is a 370" with around 12:1 SCR, DCR around 8.6:1. cam is a 248/254 XE-R grind on a 110 LSA. Patriot stg. 3 heads, milled & cleaned up.
so far i have:
Morel lifters
custom 3/8" pushrods
HS roller rockers
Xtreme dual springs shimmed to (.050") coilbind. installed press. is around 165lbs. open is about 400psi.
i've had some valvetrain issues in the past & now that the motor is getting a freshen up i am working on making the valvetrain almost bullet proof. the motor is a 370" with around 12:1 SCR, DCR around 8.6:1. cam is a 248/254 XE-R grind on a 110 LSA. Patriot stg. 3 heads, milled & cleaned up.
so far i have:
Morel lifters
custom 3/8" pushrods
HS roller rockers
Xtreme dual springs shimmed to (.050") coilbind. installed press. is around 165lbs. open is about 400psi.