Will this work please help me
05-19-2003, 08:06 PM
#1
TECH Junkie
Thread Starter
iTrader: (12)
Join Date: Jul 2002
Location: Austin, TX
Posts: 3,422
Likes: 0
Received 0 Likes
on
0 Posts
Will this work please help me Hey guys I need some opinions
I have a corvette motor 2001 stock I put in an Mti X 1 cam specs are 230/227 .591 .571 on 112 lsa I have two seats of heads 5.3 and 5.7 I told my head porter to mill the 5.3 .030 over and to use this head will this work? This will be a n/a motor only so any opinions I'm only worried about the compression being too high.
Marc
I have a corvette motor 2001 stock I put in an Mti X 1 cam specs are 230/227 .591 .571 on 112 lsa I have two seats of heads 5.3 and 5.7 I told my head porter to mill the 5.3 .030 over and to use this head will this work? This will be a n/a motor only so any opinions I'm only worried about the compression being too high.
Marc
05-20-2003, 12:48 PM
#3
Banned
Join Date: Sep 2002
Location: Azle/Saginaw, Tx
Posts: 5,581
Likes: 0
Received 0 Likes
on
0 Posts
Re: Will this work please help me compression wont be TOOOOO high if you don't mind, but you might look into a set of 7.35 pushrods(i think that's the right length) to compensate for the smaller chamber.