LS1RedZ

iTrader: (19)

Yes I know everybody asks this question. I have been searching all over tech for some answers but yet to have found any.. Just wondering if any of you guys have these heads and what cam to use to maximize the use of these heads. I had an X-1 cam, but i am looking for something a little bigger like the vindicator.. The motor is stock cubes (LS1), but has to be bored out about .020 because of the burnt up piston that left aluminum on the cylinder wall.. I will also be getting a pulley, 1.7 harland sharps and maybe a Fast 90/90 setup... So any help would be much appreciated. Thanks

Guido1

go for at least 224/224 cam, check out the cam for me thread, for stock displacement and good streetability id wouldnt go larger than 235 on intake