Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

advice plz!

Thread Tools
 
Search this Thread
 
Old 10-29-2007, 12:14 AM
  #1  
TECH Fanatic
Thread Starter
iTrader: (12)
 
01SOMSS!'s Avatar
 
Join Date: Aug 2006
Posts: 1,296
Likes: 0
Received 0 Likes on 0 Posts
Default advice plz!

so far i have
lid &k&n ,tb bypass,free ram air, ls6 maf, Lt's w ory, corsa,car came w/ ls6 manifold, other mods w/ no hp gains... pro 5.0, w/ lous short stick, bilstein shocks, eibach springs.
coming soon
410's
ported TB or nick williams 90 mm
underdrive pulley
TSP magic stick 3 cam 237/242, .603"/.609"
plus tune....

will i go through springs often w/ that cam?
anything else i should do? i am going to get the heads next summer.what numbers will I get with out the heads? any suggestions on parts to get or change are welcomed.thanks!

Last edited by 01SOMSS!; 10-29-2007 at 12:46 AM.
Old 10-29-2007, 12:27 AM
  #2  
11 Second Club
iTrader: (12)
 
TARZAN's Avatar
 
Join Date: Dec 2003
Location: Memphis Area
Posts: 1,312
Likes: 0
Received 0 Likes on 0 Posts

Default

Well, unless you upgrade intakes, you won't be able to run the Nick Williams 90mm TB, for an LS6, a ported stocker should do just fine.

Also, avoid the 4.10's in you plan on launching the car, on a good set of sticky tires, they won't hold.

I may have over looked it, but I don't see a clutch listed. If you don't have one, its more than needed.

Are you looking for a 1/4 mile car? A corner carver? An all around fun DD?

-Will
Old 10-29-2007, 12:45 AM
  #3  
TECH Fanatic
Thread Starter
iTrader: (12)
 
01SOMSS!'s Avatar
 
Join Date: Aug 2006
Posts: 1,296
Likes: 0
Received 0 Likes on 0 Posts
Default

a cruiser that has *****. I want 400-450rwhp. i know i'll need the heads for that.




All times are GMT -5. The time now is 08:11 AM.