Honing cylinders
12-07-2007, 08:33 PM
#1
12 Second Club
Thread Starter
iTrader: (6)
Join Date: May 2006
Location: Orange, CA
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
Honing cylinders Block rebuild on a block that had 130k miles on it. Wanted to go in with a honing stick to re etch the cross etchings, I'm not sure how much material this will take off and I want to re use the stock pistons. Question is will I have to use bigger rings or will stock size suffice and not cause any problems? Thanks in advance.
