johnLs1camaro

iTrader: (28)

ok i just got my H/C swap done and my car was idling at 2000 i found out i had a vacuum hose not on so i put it on the car and my idle went to 900 after running it 2 times the car went back to idle at 2000 and all the vacuum lines were attached do you have and ideas what could be wrong also when i push on the gas it gets stuck like say i rev it to 3 grand it stays there for a few seconds and then drops is that normal just because i dont have a tune or what and also i switched from 98 to 99+ style head is there anything i could have forgot???

Tainted

iTrader: (9)

id make sure every little hose is put on and the TB and any other palces are torqued to spec so that no air escapes or comes in w/o being metered.

otherwise, maybe your IAC is messed up

johnLs1camaro

iTrader: (28)

everything was torqued to spec

DarkJuggalo

iTrader: (6)

did you get a SES? my old car did this, it was a throttle positioning sensor. id recheck everything make sure nothing is loose.