What do you of my results 2000 camaro
#1
On The Tree
Thread Starter
Join Date: Nov 2004
Location: middle east kuwait
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
What do you of my results 2000 camaro
Engine Stock bottom end new rebuilt Cam G5X3 Heads Patriot Ls6 stage 2 (2.02/1.57/59cc) Morel Hydraulic Lifters LS1 with Link Bar Setup (92mm FAST Intake and Nick Williams 90mm TB)
Headers Long Flowtech Y pipe With Electric cutout
Gear M6 Stage 3+spec Package with flywheel
Read End Richmond 3.42 Gear Eaton Posi 28 spline unit TA Performance Rear-end Girdle.
On the dyno I made 466 Rwhp and 429 torq
She runs sweet on the road
Headers Long Flowtech Y pipe With Electric cutout
Gear M6 Stage 3+spec Package with flywheel
Read End Richmond 3.42 Gear Eaton Posi 28 spline unit TA Performance Rear-end Girdle.
On the dyno I made 466 Rwhp and 429 torq
She runs sweet on the road
#3
On The Tree
Thread Starter
Join Date: Nov 2004
Location: middle east kuwait
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
It was tuned by my friend on a dynojet. I wanted over 475 Rwhp am going to change my headers to Kocks and get an electric water pump.
Do you think if I use AFR heads there will be any difference
Do you think if I use AFR heads there will be any difference
Last edited by mohammed_k81; 03-31-2008 at 09:33 AM.
#7
On The Tree
Thread Starter
Join Date: Nov 2004
Location: middle east kuwait
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
Am running Nitto Tr555 245 50 16 The rear-end is good for now and I would say it cost me around hmmm $6500 or a little more that's everything even tires buts more expensive for me because my parts are ship from the States to the middle east
Trending Topics
#11
TECH Junkie
iTrader: (5)
Join Date: Feb 2007
Location: Key West, Florida
Posts: 3,183
Likes: 0
Received 0 Likes
on
0 Posts
so i have to search just so i can comment on the performance of his car?
how bout ya just list them..
anyway...
nice numbers
so that big of a cam, and heads milled to 59cc...did you have to flycut?
how bout ya just list them..
anyway...
nice numbers
so that big of a cam, and heads milled to 59cc...did you have to flycut?
#15
It is proper message board courtesy to search before starting a new thread in which you ask old, repeatedly answered questions...However, a search is not required when asking the OP a question. Welcome to dat der interwebz. Be cautious. It's an abstruse system.
#19
TECH Senior Member
iTrader: (3)
Join Date: Apr 2006
Location: Western Burbs of Detroit
Posts: 6,524
Likes: 0
Received 1 Like
on
1 Post
With all the $$$$ you got wrapped up in your project, why didn't you go with a set of Tony M's Mamofied AFR 205's or TFS 215's ?? Would've made more power then the Patriot LS6 heads. Not knocking Patriot in anyway but results speak for themselves.