MTI stealth cam-what springs? Are TI retainers necessary?
#1
Staging Lane
Thread Starter
Join Date: Nov 2001
Location: Warren,MI
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
MTI stealth cam-what springs? Are TI retainers necessary?
I am going to order the MTI stealth cam:
220/220 .581 115lsa
Can I use the comp 918 springs? What about Manley Springs?
I am sure any chrome moly 7.40" push rod is fine, correct?
Will I need to have TI retainers, or steel, or are the factory retainers good enough?
Rev limter is set at 6400, so no crazy rev's. Finally, in your opinion how much more hp would this cam give me over the 02 Zo6 cam?
2001 T/A Firehawk A4
Thanks,
Marco
220/220 .581 115lsa
Can I use the comp 918 springs? What about Manley Springs?
I am sure any chrome moly 7.40" push rod is fine, correct?
Will I need to have TI retainers, or steel, or are the factory retainers good enough?
Rev limter is set at 6400, so no crazy rev's. Finally, in your opinion how much more hp would this cam give me over the 02 Zo6 cam?
2001 T/A Firehawk A4
Thanks,
Marco
#2
TECH Fanatic
Join Date: Jan 2002
Location: Houston, TX
Posts: 1,471
Likes: 0
Received 0 Likes
on
0 Posts
Re: MTI stealth cam-what springs? Are TI retainers necessary?
Jayson told me the Manley springs are fine for it. I asked this b/c I have Manley springs on my heads already. I have been looking at this cam as well. I admit the lift concerned me too.
Didn't ask about the 918's. I have Ti retainers already too.
Mike
Didn't ask about the 918's. I have Ti retainers already too.
Mike