m.lion

Who should I send them to? N/a build.415

214Chevelle

Where are you located?

427zm

iTrader: (9)

Richard @ WCCH or Darin Morgan @ Reher Morrison. Prepare to wait a little either way. When I spoke to them last week, it was a 3 week lead time.

Zfan

Chris Frank @ Frankenstein cylinder heads in Joshua,TX. Google him.

427zm

iTrader: (9)

Yes, he is straight legit as well. He hand ports a lot of his stuff and his work is art using aluminum. He did a C6Z up here in the metroplex that previously had WCCH stage 2 heads on it, and with the same cam, the car produced 30 additional wheel (592). He cost some $$$$ though. Of course Reher isn't cheap either. Then again, you are talking to shops that almost exclusively deal with NHRA and NASCAR teams.

imma_stocker

iTrader: (19)

The best will all cost $$$$. Its a scientific art.

TransWS6Am

iTrader: (41)

Total engine airflow, top notch guys!

Blackpanther99

iTrader: (8)

Try looking for the nearest quality machine shop to you.

litle88

iTrader: (20)

WCCH
AI
TEA
Brian Tooley
LPE

To name a few.

Gray86hatch

iTrader: (83)

There is more to it than a grinder or cnc machine.

Be very careful having someone hand port them some guys are just flat out hacks.

I have had two sets hand ported and the work to them was very minor. Had a set of cnc and they were not much faster than my light hand port heads.

Tim

m.lion

Hey tim got lots of questions could I give you a call and not do all this typing

Gray86hatch

iTrader: (83)

Send me a pm I will be avalible all day tomorrow.

allan808

iTrader: (3)

Landspeed! I payed $699 on a stage 2 flows 350 cfm