Clearance ?
#1
On The Tree
Thread Starter
iTrader: (57)
Join Date: Mar 2004
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
Clearance ?
Hey everyone I just bought a 2004 GTO and I just purchased a Cam (236/240 .606/.613 111 LSA) for it and I was wanting to throw some hand ported 5.3L heads on it I think they may need to be milled a little bit just for clean up. My question is if I have the milled say .010 will I still clear the pistons with that cam and a stock bottom end? Any help would be great
#2
TECH Junkie
iTrader: (2)
Join Date: Jan 2006
Location: Fort Wayne, IN
Posts: 3,776
Likes: 0
Received 0 Likes
on
0 Posts
Hey everyone I just bought a 2004 GTO and I just purchased a Cam (236/240 .606/.613 111 LSA) for it and I was wanting to throw some hand ported 5.3L heads on it I think they may need to be milled a little bit just for clean up. My question is if I have the milled say .010 will I still clear the pistons with that cam and a stock bottom end? Any help would be great
#3
Staging Lane
Join Date: Feb 2009
Location: Auburn, GA
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
Its hard to say for sure, but it will be very close. You would be best to measure with clay. I have a smaller cam, non-milled heads, and thinner head gasket and I had to cut.