LS7 rings
#1
TECH Fanatic
Thread Starter
iTrader: (3)
Join Date: Mar 2007
Location: Middle east , Kuwait
Posts: 1,591
Likes: 0
Received 0 Likes
on
0 Posts
LS7 rings
I have LS7 engine , i'll rebuild it because it has bad rings and smoking , wich ring should i go with ?
- 4.125 Bore, 1.5 - 1.5 - 3.0 mm
or
- 4.130" + .005" 1.5/1.5/3.0
?
- 4.125 Bore, 1.5 - 1.5 - 3.0 mm
or
- 4.130" + .005" 1.5/1.5/3.0
?
#3
FormerVendor
iTrader: (6)
LS7 sleeves aren't thin. Bored them +.030 for N/A to patch up a block.
One issue have with them, 90% of pistons for them are 4.125", the block itself is 4.126", once you go to hone the block its only going to get bigger. I'd like if the piston companies would make pistons 4.127" or 4.130" more so then 4.125".
If you're reusing the stock pistons, i'd go with 4.125 +5.
One issue have with them, 90% of pistons for them are 4.125", the block itself is 4.126", once you go to hone the block its only going to get bigger. I'd like if the piston companies would make pistons 4.127" or 4.130" more so then 4.125".
If you're reusing the stock pistons, i'd go with 4.125 +5.