What happened to TFS LS3 heads?
#1
TECH Senior Member
Thread Starter
What happened to TFS LS3 heads?
So what ever happened to Trick Flow Specialties LS3 heads they were previewing here on LS1tech a while back?
Trending Topics
#11
LS1Tech Premium Sponsor
iTrader: (4)
Give them a break guys, it takes a lot of time to engineer & test a cylinder head before throwing it to market. This isn't like building a header & seeing if it fits. There's a lot of testing & design that goes into a cylinder head.
We just finished the PRC LS3 heads & are starting to ship. I didn't think it would take this long to finish either, so I completely understand that it takes time.
We just finished the PRC LS3 heads & are starting to ship. I didn't think it would take this long to finish either, so I completely understand that it takes time.
__________________
Jason
Co-Owner, Texas Speed & Performance, Ltd.
2005 Twin Turbo C6
404cid Stroker, 67mm Twins
994rwhp/902lb ft @ 22 psi (mustang dyno) www.Texas-Speed.com
Jason
Co-Owner, Texas Speed & Performance, Ltd.
2005 Twin Turbo C6
404cid Stroker, 67mm Twins
994rwhp/902lb ft @ 22 psi (mustang dyno) www.Texas-Speed.com
#12
TECH Senior Member
Thread Starter
Give them a break guys, it takes a lot of time to engineer & test a cylinder head before throwing it to market. This isn't like building a header & seeing if it fits. There's a lot of testing & design that goes into a cylinder head.
We just finished the PRC LS3 heads & are starting to ship. I didn't think it would take this long to finish either, so I completely understand that it takes time.
We just finished the PRC LS3 heads & are starting to ship. I didn't think it would take this long to finish either, so I completely understand that it takes time.