Pushrod dimensions?
#1
Staging Lane
Thread Starter
Pushrod dimensions?
I see wall thickness given for aftermarket replacements; what's the stock wall for a 6.0?
5/16" X .080" looks pretty common, but leaves very little room for improvement by increasing wall thickness.
What's the largest OD that clears without mods?
5/16" X .080" looks pretty common, but leaves very little room for improvement by increasing wall thickness.
What's the largest OD that clears without mods?
#3
Staging Lane
Thread Starter
Thanks. Just by math, a direct swap of 11/32" for 5/16" with the same wall thickness is a big improvement: 42% higher bending resistance with only about 14% more weight.