PDA

View Full Version : Drag Racing Tech


Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 [75] 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103

  1. Will stock brake pads work on my Moser 12 Bolt rear
  2. How difficult is it to take the backseat out and put it back in?
  3. Shift Rpms,vs. 1/4 times
  4. Hope to have a set of M/T Drag Radials at NvsS
  5. post# of runs before factory clutch failed
  6. M&H Musclecar drag pics
  7. may 23 Island dragway greatmeadows NJ, who's up for test and tune
  8. 15w-50 oil
  9. 502 69 Camaro
  10. 15x10 Weld + 275-60-15 Nitto anyone done it?
  11. 1st time at track, what psi should I be running on stock tires?
  12. Better Luck This Year
  13. What alum flywheel worth in ET & MPH?
  14. ran 11.3 @123
  15. Heads, cam, and bolt-ons results
  16. 4 ply or 8 ply Sportsman Pro Fronts?
  17. S&W vs. Wolfe roll bar. Pro's and Con's
  18. Where the hell is my mph?
  19. Aerospace rear brakes????
  20. Video of buddies LS1 Wagon
  21. Density altitude calcualtion- station in/hg
  22. Anyone done through the floor SFCs?
  23. New "altitude" best for the Blue Meanie, Kook's 1 7/8" first test.
  24. Seat attatchment to rollbar
  25. My LS1s first time to track
  26. can someone tell me if my ET/mph was good
  27. 60 foot time vs. 60mph time
  28. ABS delete questions
  29. ARE H/C New Best
  30. 9.6's n/a 2300+ DA
  31. just a quick question
  32. Thanks to Camaroholic
  33. Trex vs. TR230 track results!!
  34. Nitto Tire pressure and rpm launch?
  35. Track
  36. New "cam only" best last night
  37. New Drag Radial Record
  38. New Best Time, I was surprised!
  39. Which full slicks work best?
  40. New best tonight...
  41. Air Pressure in 315/35/17 nittos?
  42. Were Can I Get Some Drag Slicks 26-10-16 New Or Used..
  43. Finally got into the 11's, with no traction...
  44. Hurst Roll control Shift Knob
  45. Taner's 9.58 Vid
  46. Layed down some 7's with streets
  47. Tire size effecting track times
  48. Nominate your favorite LS1TECH rides!
  49. What to expect?
  50. Where will too much tire hurt me?
  51. This is awesome (vid inside)!!
  52. Paging Madman...(or anyone, inner fender trimming advice)
  53. BMR Trak Pak and low 1.4 60fts?
  54. Ran for the first time tonight
  55. Accufab? coilovers....
  56. Is this a shitty pass?
  57. help me estemated et
  58. Launch Video
  59. Sticky street tire choices
  60. Can you have too much weight transfer?
  61. Norwalk, OH track..what is DA
  62. Anyone test a M/T drag radial?
  63. I took the car to Norwalk last week
  64. Tire and 10 bolt ?
  65. Is my suspension good for drag racing......
  66. What do you think ill run?
  67. First run with new TCI prepped Yank converter
  68. What do you think I will run?
  69. raceing this weekend
  70. Who's taken out both bumper supports?
  71. Suspension Question
  72. What do you think I will run?
  73. Not a 9.5 pass but a vid none the less ;)
  74. people running autometer tach's.....gotta question
  75. A4 with 4.10's???
  76. New track #'s for 99 c5 w/ head/cam swap
  77. More MIR videos: Bone stock C5 12.89@109
  78. Couple of Battery Box, Kill Switch Q's...
  79. Optimum Tire Size ???
  80. MIR Video: 10.2 @ 133
  81. Quick Quiz - Multiple Choice
  82. Updated Pictures of the ride
  83. what drag race only brakes are you guys using?
  84. New best today @ MIR....10.2 @ 133
  85. Solid Axel C5 runs 9.45 @ 144.7 N/A
  86. Race Results-I have good news again!
  87. Special Thanks To Madman
  88. The Hot Rod runs 10.98 BUT!!!!!!!!!!!!!!
  89. My 1/4 mile best...
  90. San Antonio Raceway vs Alamo Raceway times
  91. Declined?
  92. Bowman Motorsports 25-2 Pictures Updated
  93. Track Results
  94. 9.58 @ 141.70 mph.... new pb
  95. anyone running 27 inch hoosiers?
  96. Any ideas on what I should run at sea level?
  97. Anyone run MT Sportsman fronts on the street?
  98. Anyone going to the track this weekend?
  99. M6 to A3 Switch - Need a little help
  100. Looking for Wolfe Weld In Rollbar Install Pics..
  101. Installing roll bar tomorrow.. need some clarification
  102. Farmington Results
  103. Drag Slips Database
  104. heads and cam records N/A
  105. some decent launching video's from MOKAN
  106. Cam only/ TH400 game
  107. Linelock wiring questions
  108. Best way to secure Dynabatt?
  109. Npr
  110. finally 2 years in the making, 10's N/A
  111. WTF...Ive added things, removed weight, etc., but STILL no improvements! This is BS!
  112. First Time Ever To The Track
  113. BMR k-frame wont go, am I missing something?
  114. Battery Disconnect switch wiring
  115. 26x11.50-16 ET Streets/426 RWHP/396RWTQ
  116. 9 inch or 12 bolt? 3:90s or 4:10s, ahhhh...
  117. How are my times?
  118. New bolt-on only stock TC best!!!!
  119. what is 117 - 118 mph trap worth?
  120. 6.0 liter fitment issues?
  121. BFG Comp T/A Drag Radial discontinued???
  122. New Best 11.3 @ 119
  123. needed at the strip??
  124. ET fronts on the street?
  125. QA1 question...
  126. M6 Bolt on Times Record???
  127. Need Help ASAP re: around the dash cage
  128. Things you do/change/install/remove at the strip to help times?
  129. MTI 427 Super Stroker !
  130. Those with calipers ground for wheel clearance...
  131. Help me get better 60ís (6spd & 315)
  132. May 15, Cecil County MD, Vettes vs. Vipers American Super Car Challenge
  133. MT ET drag redial, DOT tire, or Slick
  134. Wolf rear swaybar on the street?
  135. Rear squats to much.
  136. Calling silversurfer
  137. S&W cages?
  138. Need tire size opinons???
  139. How are these times?
  140. Oh yeah, got the elusive 11, converter rocks!
  141. Pinion angle was +1!!! Set it to -3. Do you think that was hurting my 60 ft.?
  142. Et Street 26\ 11.5\ 15????
  143. pro star 15x10
  144. Drag Racing the truck.
  145. Al Corda is flying at Bristol!
  146. Help with Drag set up
  147. Super Chevy Show results
  148. Anyone running the Wolfe Racecraft T/A?
  149. Rpm fall off %
  150. Who is ACTUALLY the first LS1 car in the 9's?
  151. Rollbar needed?
  152. 60' times with Nittos and 2.73 rear
  153. Dam , I Finally Got into the 11s
  154. Results from the HOT ROD Pump Gas Drags!
  155. Spring and Pushrod replacement not stock internal?
  156. First time ever at the track
  157. Lebanon Valley Action today
  158. Guessing Game... anybody?
  159. ?? Mounting 26x11.5-17 MT ET streets on a 9.5" rim??
  160. Another 1/8 mile best 6.48 @104.36!!!
  161. pro and cons of 15x10 welds
  162. MT Sportsman Pro comparison
  163. The Texas Mile is back
  164. Bogart, Centerline, or Weld?
  165. New Best!
  166. What more can I do to improve my sixty-foot times?
  167. 2nd time Out.
  168. Can i make the 6's with my set up
  169. How can i improve my time or can i?
  170. What would my car run in the 1/4?
  171. Does a standalone fuel cell have to be SFI certified to be legal to run at the track?
  172. Pics of Madman torque arm?
  173. Best launch technique?
  174. Rollcage install in central TX area
  175. ET Drag/ConvoPro Q
  176. New Best :D
  177. 11.58 on street tires
  178. newbie question here
  179. Critique my 1/4 mile (it sux and i need good advice)
  180. why am i getting low 14's
  181. Are relocation/anti-squat brackets beneficial on a stock height car?
  182. Helmet Rating For Drag Racing?
  183. Does bypassing the a/c with the belt help at the track and if so, how much?
  184. ET lose with a 6pt. roll bar?
  185. Which to buy first?
  186. Opinion on times
  187. are 50's good for the track?
  188. Drag suspension gurus in
  189. Still can't launch.. so close to 12's
  190. Hmmm what to do? KBDD SFC's and wolfe cage conflict.
  191. Finally, some good track results!
  192. pros & cons of bolt in vs. weld in roll bar
  193. New best at Cecil Co
  194. So what is the deal with A/C?
  195. Racing photos needed! Post them up!
  196. 4.10's with a 27 inch tire?
  197. Do they fit for track??
  198. Does adjustment on LCAs, PHB, and TA have any affect of 60 ft. and ETs?
  199. First Track Run In My T/A
  200. 9.55@139.8 1430' Da
  201. How fast are guys running with bone stock suspension?
  202. getting closer to where i should be
  203. Pump gas Spectators???
  204. Anyone use this yet?
  205. APE Shop Cars Gets 25.4 Cage
  206. how important are springs on my SS
  207. 11's elude me once again...So close
  208. finally in the 12s....but MPH still sucks
  209. Ohhh so close to the 11's
  210. Went to track today - Union Grove
  211. AFR 205 track times, tony, it's been a week?
  212. Someone Help Me With This Suspension!
  213. what times to expect?
  214. Anyone going to HR Pump Gas Drags or NMRA/Columbus next weekend?
  215. Hot Rod Pump Gas Drag tune up is ready :)
  216. What is the Drag Radial Record?
  217. How To Launch
  218. PICS INSIDE of my cage/car
  219. A4 guys running 1teen 120 traps w/ 410s...
  220. Atco rocked this friday.
  221. What psi in Nitto 315's?
  222. What is the cam only record?
  223. what is my max et.?
  224. Race gas?
  225. Track Results.. 120.5 MPH NA SI
  226. Powershifting?
  227. Post Hal settings that work best for you at the track.
  228. Line Lock Question
  229. Launching tips for A4 and street tires
  230. Rear ride height and 60' times
  231. Outlaw Pontiac Drag Series Race#3 at Mason Dixon is April 25th
  232. Wheelie bars?
  233. My '01 z28 convertible weight - happy
  234. Question on QA1's
  235. The Texas Mile is Back
  236. What drag brakes should I order?
  237. Which Torque Arm???
  238. new best 1/8
  239. Outgrew the BFG's 12.11@120.07
  240. Should I go threw the water box or not?
  241. WHY...im getting low 14 times and im not stock
  242. And he walked away
  243. Finally in the 11's cam only.
  244. 1/4 Mile Times
  245. Daily drivers with a roll cage, please come in.
  246. AP Engineering Shop Car Update
  247. How much will lowering my SS screw me?
  248. Will an aftermarket torque arm help my 60ft?
  249. First Track Times
  250. Anyone have full cage with bars going around dash, instead of through?