H/C m6 guys with 200+ n20
10-14-2008, 11:49 AM
#3
TECH Fanatic
iTrader: (9)
Join Date: May 2005
Location: Longview, TX
Posts: 1,085
Likes: 0
Received 0 Likes
on
0 Posts
I havent yet, but I will be ordering a plate soon so that I can. I have very poor distrobution on a 150 shot single fogger, I'm hoping that a plate will fix some of that.
I run 10.2's on the 150 shot so I'm sure I will be all over 9's with a 200.
I run 10.2's on the 150 shot so I'm sure I will be all over 9's with a 200.
10-15-2008, 07:41 PM
#7
I have only sparyed a 100 shot so far and ran a 10.5 @ 130 with a 1.45 60ft.
I'm going to up my shot in steps to see what it takes to break into the 9's
Be ready to break **** with your drivetrain.My clutch slipped on the dyno when it was tuned last. So I'm thinking my clutch is going to go first before anything else. After about 20 hard launch's with a 1.45-1.49 60ft. I blew my ring and pion in my spooled 12 bolt rear. I switched to a set of pro gears to avoid this from happenning again. a 200-250 shot will show your weakest link.I thought for sure my clutch would go before my rear.
I'm going to up my shot in steps to see what it takes to break into the 9's
Be ready to break **** with your drivetrain.My clutch slipped on the dyno when it was tuned last. So I'm thinking my clutch is going to go first before anything else. After about 20 hard launch's with a 1.45-1.49 60ft. I blew my ring and pion in my spooled 12 bolt rear. I switched to a set of pro gears to avoid this from happenning again. a 200-250 shot will show your weakest link.I thought for sure my clutch would go before my rear.