Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

I need advice

Thread Tools
 
Search this Thread
 
Old 10-30-2008, 12:17 PM
  #1  
On The Tree
Thread Starter
 
antonio84's Avatar
 
Join Date: Sep 2008
Location: midland, Tx
Posts: 111
Likes: 0
Received 0 Likes on 0 Posts
Default I need advice

thinking about adding roller rockers to my setup, the question is should i or should i not and if so what type roller rockers should i get? What would ya'll do in my position?
Old 10-30-2008, 12:31 PM
  #2  
TECH Senior Member
iTrader: (8)
 
SOMbitch's Avatar
 
Join Date: Sep 2007
Posts: 6,881
Likes: 0
Received 3 Likes on 3 Posts
Default

Waste of time unless you go aftermarket heads. Stockers are light and well designed. You may want to just let Harland Sharp upgrade them so you never have to worry about them puking needle bearings.
Old 10-30-2008, 01:02 PM
  #3  
TECH Fanatic
iTrader: (1)
 
NC98Z's Avatar
 
Join Date: Sep 2003
Posts: 1,306
Likes: 0
Received 0 Likes on 0 Posts
Default

Wasted money that could be spent on a tune you need now.
Old 10-30-2008, 01:14 PM
  #4  
TECH Junkie
iTrader: (5)
 
teke184's Avatar
 
Join Date: Feb 2007
Location: Key West, Florida
Posts: 3,183
Likes: 0
Received 0 Likes on 0 Posts
Default

money better spent on a better cam.

but it would be a good way to increase the lift on the hotcam. but it is alot of money for a small gain.
Old 11-03-2008, 12:23 PM
  #5  
On The Tree
Thread Starter
 
antonio84's Avatar
 
Join Date: Sep 2008
Location: midland, Tx
Posts: 111
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by SOMbitch
Waste of time unless you go aftermarket heads. Stockers are light and well designed. You may want to just let Harland Sharp upgrade them so you never have to worry about them puking needle bearings.
I already have the 5.3 heads ready to install just need more advice because I'm getting different opinions.




All times are GMT -5. The time now is 04:09 AM.