Bad_tx_Z28

iTrader: (3)

ok guys, before i bought my new keyless entry remotes i tested the the keyless entry module by jumping the A and G ports on the DLC. The locked cycled and evey thing worked. I got my remotes in today, and i go to jump the A and G ports and nothing happens. What the hell?? So, do i need to reset the PCM before i the keyless entry module will go into pairing mode or what. Any help is greatly appreciated!!

Bad_tx_Z28

iTrader: (3)

nevermind guys, the paperclip i was using didnt want to work. I finally got mad and used a piece of wire and it worked. The only problem now is the Lock button doesnt lock the doors. Every other button works fine. Any ideas?

Bad_tx_Z28

iTrader: (3)

anyone?

Bad Lt1 Camaro

iv had this problem before, i reset the computer and went through the programing process again. It worked for me. Also check to see if the battery isnt dead lol

Bad_tx_Z28

iTrader: (3)

the lock button didnt work for you either? nah my batt is good. Optima redtop.

Bad Lt1 Camaro

no it didnt work for either remote until i reprogramed it. since then i havnt had ne more problems. if that doesnt help i dont know any other solution. good luck

Bad_tx_Z28

iTrader: (3)

thanks, i appreciate it!