Replacing Head Gasket Project
11-15-2008, 09:10 PM
#1
Staging Lane
Thread Starter
Join Date: May 2007
Location: Chico, Ca
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Replacing Head Gasket Project Alright, check out the progress! I'm replacing a blown head gasket. Everything went pretty smooth. The intake was stuck on there good.
I'm going to take the car and heads to a machine shop monday to have them checked out, to make sure they arn't warped and to polish the matting surface. Is there a way I can clean the intake and inside the block where the spider is?
I'm going to take the car and heads to a machine shop monday to have them checked out, to make sure they arn't warped and to polish the matting surface. Is there a way I can clean the intake and inside the block where the spider is?
