WhitePhoenix99

iTrader: (12)

I'm in the proccess of installing a cap & rotor on my lt1 and I'm stuck at taking the old one off. What size are the bolts that hold the cap on? I tried a 4mm but that was too big. I don't have anything smaller. I checked napa and they don't either apparently. What do you guys use?

James Montigny

iTrader: (13)

They're not hex, they're inverted Torx-25 (E-4)

92camaroguy

iTrader: (1)

Or you can take one of the screws off the tb plate on top and use it.

leadfoot4

iTrader: (1)

Excellent tip!



Just make sure you don mess up the threads on the screw, so you can reuse it!

WhitePhoenix99

iTrader: (12)

Ok thanks guys i'll have to get a set of those

cammed93TA

I call it the babeeee