417 RWHP and 394 TQ after UD pulley install
#1
8 Second Club
Thread Starter
iTrader: (18)
Join Date: Oct 2002
Location: Waterloo, Ontario
Posts: 2,609
Likes: 0
Received 0 Likes
on
0 Posts
417 RWHP and 394 TQ after UD pulley install
Well I ventured out to the dyno last night with a few friends. I made 2 pulls just to see where the car was at after my dyno back in June after the cam install. This time out I installed my underdrive pulley which wasn't available when I did the cam install. I was pleasantly surprised after only 2 pulls. First pull was a 419/392 and the next pull was 417/394. The tune In my car was bang on, 12.8 afr all across the board. I may take the cats off next and see how much can be gained. So far the car has run a best of 11.60@121.88 with a 1.89 short in the middle of summer (80 degree's) . My short time's suck because I'm still trying to figure out a way to launch the car without breaking my tranny and rear end again. It's gettin much cooler here now so I'm hoping to see much more improvements in ET and MPH. I'm shooting for 11.3@122-123. now I have to decide if want MTI's new head's or wait for the AFR's, then we also have the FAST intake as well. Decisions, decisions.
#4
TECH Resident
Join Date: Apr 2003
Location: Tulsa, Ok
Posts: 791
Likes: 0
Received 0 Likes
on
0 Posts
Re: 417 RWHP and 394 TQ after UD pulley install
great numbers. how much did you dyno before the pulley? i've got one on my car that was installed at the time of my dyno, i'm just curious how much you saw from it. TIA