Manual Transmission - duel disk clutch install question

I'm installing a duel disk clutch in my car and I was wondering if this bolt was to be tight or is there to be a space? all 3 bolts are the same and bottom out leaving the same gap. I bought it used so I do not have the instructions...

http://i98.photobucket.com/albums/l272/1BadChad/99%20SOM%20Camaro/pictures100.jpg
http://i98.photobucket.com/albums/l272/1BadChad/99%20SOM%20Camaro/pictures101.jpg
http://i98.photobucket.com/albums/l272/1BadChad/99%20SOM%20Camaro/pictures102.jpg

This si purely specualtion: I would think that it needs to bottom out. Looking at that pic, I would think the bolt needs to be threaded in further. Again, speculation on my part.

That is by design. Thats how my RAM dual disc is setup.

Check out this image - http://www.ramclutches.com/ls1%20dual%20net.pdf

That is by design. Thats how my RAM dual disc is setup.

Check out this image - http://www.ramclutches.com/ls1%20dual%20net.pdf



That is why it was purely speculation on my part:D

Thanks for the reply ans link, I called LMR and he said that is how they were designed.

Now I need to get my clutch adjusted..